Be sure to replace the serial device string with that of the device on your workstation. These examples demonstrate all three applications and assume that the serial device is "/dev/ttyUSB0" which is common for USB adapters. There are many serial terminal applications for Linux, three common used applications are 'picocom', 'screen', and 'minicom'. The serial console is provided through this port at 115200 baud, 8n1, with no flow control. The TS-7670 includes a USB device port, this uses an 8051 based microcontroller to create a serial device on a host PC. In this case you can connect to either ts7670-4f47a5.local or ts7670-4f471a.local This will show you the mac address you can use to resolve the board. Timestamp A/R Flags if Domain Service Type Instance Nameġ0:27:57.078 Add 3 2 local. If your system is configured with zeroconf support (Avahi, Bonjour, etc) you can simply connect with: When building a custom kernel from source this date will be changed and may not always reflect the kernel build date. The TS-BOOTROM build date reflects when then imx-bootlets were built. The i.MX28 internal bootrom prints out the strings of letters to indicate various stages of its internal process. > Copyright (c) 2013, Technologic Systems HTLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLFLC Once you have applied power you should look for console output. An ideal power supply for the TS-7670 will allow up to 5 W to allow peripherals to be powered as well. The TS-7670 will require approximately 1.1 W at idle. The TS-7670 has an input voltage range of 8-28 VDC through the main power connector which offers screw terminals for secure wiring. Inappropriate handling may cause damage to the board. Disconnect the power source before moving, cabling, or performing any set up procedures. Development will include accessing drives formatted for Linux and often Linux based tools.īe sure to take appropriate Electrostatic Discharge (ESD) precautions. It may be possible to develop using a Windows or OSX system, but this is not supported. Most of our platforms run Debian and if there is no personal distribution preference this is what we recommend for ease of use. For users in Windows or OSX we recommend virtualizing a Linux PC. This is a small embedded board with an NXP i.MX286 454 Mhz ARM9 CPU with 128-256 MB DDR2 RAM.Ī Linux PC is recommended for development, and will be assumed for this documentation. 6.2 Battery Backed RTC and Temperature Sensor.4.1.3 Building the Image Replicator from Source.4.1.2 Running the Image Replicator Tool.4.1.1 Creating a USB Image Replicator Disk.2.3.1.2 From USB storage device (USB update mechanism).2.3.1.1 From on-board media (SD/NAND/eMMC).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |